In the market expected requirements, PTMS LITHIUM COBALT ACID MATERIAL MAGNETIC iron removal cathode monomer energy density will reach 300Wh/kg, in the next 5 years is required to reach 400Wh/kg, in 10 years the requirement is set at 500Wh/kg. Why would you want to do it in terms of energy density? In fact, the reason is very simple, in general, the higher the energy density, the longer the car can travel in a single trip. But it is also important to note that the higher the energy density, the lower the safety performance may be.
Use PTMS LITHIUM COBALT ACID MATERIAL MAGNETIC in addition to iron lithium ion positive material battery energy density is too large, also need to pay attention to the safety of the following points: lithium battery short circuit, prevent battery overcharging, prevent thermal control, need to carry out circuit protection, avoid battery combustion. The compaction density is divided into many kinds, there are the compaction density of positive material, the compaction density of negative material, the compaction density of filling soil, the compaction density of subgrade, today we will talk about the compaction density of positive material.
For the compaction density, each use PTMS LITHIUM COBALT ACID MATERIAL MAGNETIC iron removal positive material has a variety of different compaction density, in the positive material, the compaction density and energy density is generally closely related, but also true density, positive material radius, rate performance, sheet specific capacity, Efficiency, cycle performance and internal resistance are all related.
Contact: DELLA
Mob: +86-13929907491
