PTMS LITHIUM COBALT ACID MATERIAL MAGNETIC The permanent magnet rod at one end is a cylinder with an external thread, the other end is a six prism that can cooperate with the torque wrench, the six prism is located outside the mixing frame; the six prism has no magnetic ring and a width of 2cm. The external thread of one end of the permanent magnet rod matches the internal thread of the inner wall of the hollow cylinder, which can be locked to the mixing frame. The outer part can be used for disassembly, and the torque wrench can be used when installing.
The length of the permanent magnet rod is 10cm, and the gap between the PTMS LITHIUM COBALT ACID MATERIAL MAGNETIC permanent magnet rod and the inner wall of the internal mixing tank does not exceed 1cm. Permanent magnet rod 3 magnetic force> 10,000 gs. The center line of the feeding pipe and the axis of the rotating shaft are on the same line. The spacing between the mixing racks is 3cm, all the mixing racks are on the same plane, and the adjacent two mixing racks are staggered 180, up and down in 180. When the mixing device is not in use.
When use, install the PTMS LITHIUM COBALT ACID MATERIAL MAGNETIC permanent magnet rod from bottom to top with the torque wrench during installation, and clean the mixing rack with dust-free cloth and alcohol again. The installation process shall be carried out in a dust-free environment.
Contact: DELLA
Mob: +86-13929907491
