PTMS LITHIUM COBALT ACID MATERIAL MAGNETIC inside the mixing tank is equipped with a mixing device, the mixing device includes a rotating shaft, a plurality of mixing frame, the rotating shaft upward from the top cover and the motor output shaft connection, a plurality of mixing frame vertically connected to the rotating shaft, the mixing frame is a hollow cylinder structure, and the internal equipped with permanent magnet rod. The center line of the feed pipe and the axis of the rotating shaft are on the same straight line.
PTMS LITHIUM COBALT ACID MATERIAL MAGNETIC There are four mixing racks outside the rotating shaft, the four mixing racks are located in the same plane, and the two adjacent mixing racks are staggered, and the spacing between the two adjacent mixing frames is moderate. The permanent magnet rod is a cylinder with external thread at one end and a six prism at the other end outside the torque wrench; the width of the magnetic ring is 2cm.
The mixing frame is equipped with an internal thread matching with the external thread at the end of the permanent magnet rod. The diameter of the mixing rack is 5cm and 8cm; PTMS LITHIUM COBALT ACID MATERIAL MAGNETIC is 10cm, and the gap between the inner wall of the internal mixing tank should not be too large. The width of the gap is 3cm. The top of the inner tank is lower than the top of the outer tank.
Contact: DELLA
Mob: +86-13929907491
