According to the core, anode material, resistance material, crucible, furnace load and so on, different temperature curves are selected. Different curves are selected according to the volatiles of PTMS LITHIUM COBALT ACID MATERIAL MAGNETIC magnetic anode material and resistance material. If the volatiles are higher, a slower temperature rise curve should be selected; otherwise, a faster temperature rise curve should be selected. When the ash content of negative electrode material and resistance material is high or the negative electrode material is relatively difficult to graphitize, the high power transmission time should be properly extended.
Because the negative electrode material is powdery material, the volatile content is high and it is not easy to discharge, which is easy to produce arc and accidents caused by high volatile content, the following matters should be paid attention to in the specific operation process: When removing iron from the negative electrode MATERIAL PTMS LITHIUM COBALT ACID MATERIAL MAGNETIC, the resistance material should be rammed to avoid arc accidents caused by the resistance material hanging between the crucible during power transmission.
Internal series PTMS LITHIUM COBALT ACID MATERIAL MAGNETIC displacement change in the process of negative material to reduce the main, so the negative material to remove iron, to calculate the stroke of the hydraulic cylinder, to ensure that there is a stroke in the process of power transmission and to ensure sufficient pressure, to avoid the loss of voltage caused by arc accidents; For both types, raw materials with coarse particles and low volatile content should be selected.
Contact: DELLA
Mob: +86-13929907491